Table of Contents
Advertisement
Installing Multiplexers
I
HXU-358 M
NSTALLING THE
Card eject tab
Step
Procedure
Whenever installing or removing units from the HMS-357 chassis, be sure to wear an
antistatic wrist strap and connect it to the ESD strap input.
1
If you have not already done so, unscrew the two hold-down lugs on each side of the chassis front
cover.
The cover folds down.
2
Plug your ESD strap into the ESD input on the front of the chassis.
3
Align the edges of the HXU-358 multiplexer card with the guide rails in the multiplexer tray.
4
Grasping the card eject tabs, gently push the card into the bay.
5
Firmly press in on the tabs until the card snaps into place.
6
Repeat
Step
3 through
7
Proceed to
"Setting Up Basic System Parameters Through the Config Menu" on page
? ? ? ?
Installer Signature
38
ULTIPLEXER
MUX card
Figure 22. Installing an HXU-358
Step
5 for the other HXU-358 multiplexer.
September 29, 2000
800-357-104-01, Revision 01
C
ARD
ESD strap input
39.
HMS-357 List 4 and List 5
Installer Check ü ü ü ü
H
H
H
H
H
H
H
Date
Advertisement
Table of Contents
