Table of Contents
Advertisement
Installing a Management Unit (HMU)
Step
Procedure
1
From your terminal emulation program, locate the release version as shown in
• For TL1 release version 3.04, proceed to
• For TL1 release version 3.05, proceed to
2
At the prompt, enter tao and then press
• If the system is managing a multishelf configuration, the Network Status menu appears, disregard
rest of this procedure and proceed to
• If the system is managing a single shelf configuration, the Shelf Status menu appears, disregard
rest of this procedure and proceed to
Proceed to
"Configuring the Management Unit" on page
If your shelf configuration does not appear, follow the bulleted procedure listed below if the following
message appears:
Please log on to local TL1 with proper privilege and re-type TAO.
– At the prompt, press
– At the
Enter TID [Local]
– At the
enter username
– At the
enter password
– At the
prompt, enter tao and then press
<
If the system is managing a multishelf configuration, the Network Status menu appears,
disregard rest of this procedure and proceed to
page
29.
If the system is managing a single shelf configuration, the Shelf Status menu appears,
disregard rest of this procedure and proceed to
page
29.
3
At the prompt, enter tao and then press
4
At the
enter password
• If the system is managing a multishelf configuration, the Network Status menu appears, disregard
rest of this procedure and proceed to
• If the system is managing a single shelf configuration, the Shelf Status menu appears, disregard
rest of this procedure and proceed to
If your shelf configuration does not appear, follow the bulleted procedure listed below if the following
message appears:
Please log off of TL1 session and re-type TAO to login TAO.
– At the
prompt, enter logoff;
<
– At the
logged out ok
– At the
password
Proceed to
"Configuring the Management Unit" on page
? ? ? ?
Installer Signature
28
Step
2.
Step
3.
ENTER
.
"Configuring the Management Unit" on page
"Configuring the Management Unit" on page
ENTER
.
prompt, enter the ID (if necessary) or press
prompt, enter superuser (default) and then press
prompt, enter public#1 (default) and then press
ENTER
"Configuring the Management Unit" on
"Configuring the Management Unit" on
ENTER
.
prompt, enter public (default) and then press
"Configuring the Management Unit" on page
"Configuring the Management Unit" on page
prompt, enter tao and then press
prompt, enter public and then press
September 29, 2000
Figure
19.
29.
29.
29.
ENTER
.
ENTER
29.
29.
ENTER
.
ENTER
.
29.
800-357-104-01, Revision 01
Installer Check ü ü ü ü
H
H
.
ENTER
.
ENTER
.
H
H
.
Date
HMS-357 List 4 and List 5
Advertisement
Table of Contents
