Mounting The Loop Handle - Stihl FS 94 R Instruction Manual

Mounting the Loop Handle

Using the Barrier Bar
A barrier bar may have to be mounted at
the loop handle to suit the tool you
intend to use – see "Approved
Combinations of Cutting Attachment,
Deflector, Handle and Harness".
The barrier bar is included with the
machine or is available as a special
accessory.
FS 94 R
Mounting the Loop Handle with Barrier
Bar
2
1
Insert the square nuts (1) in the
N
barrier bar (2) – the holes must line
up
4
5
6
1
Insert the clamp (3) in the loop
N
handle (4) and position them
together on the shaft (5)
Position the clamp (6) against the
N
shaft
Position the barrier bar (2) – note
N
position!
Line up the holes
N
Insert the screws (7) in the holes
N
and screw them into the barrier bar
as far as they will go
Go to "Securing the Loop Handle"
N
English
2
3
7
13