Fitting The Carrying Ring - Stihl FS 94 R Instruction Manual

English
Mounting the Loop Handle without
Barrier Bar
7
7
8
8
4
3
5
6
1
1
Insert the clamp (3) in the loop
N
handle (4) and position them
together on the shaft (5)
Position the clamp (6) against the
N
shaft
Line up the holes
N
Fit the washer (8) on the screw (7)
N
and insert the screw in the hole. Fit
the square nuts (1) and screw it
down as far as it will go
Go to "Securing the Loop Handle"
N
14
Orienting and Securing the Loop Handle
A
4
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance "A".
Recommendation: distance (A):
about 20 cm (8 in)
Slide the loop handle to the required
N
position
Line up the loop handle (4)
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the shaft. If no barrier bar
is fitted – lock the nuts if necessary

Fitting the Carrying Ring

Polymer Version
1
For position of carrying ring see "Main
Parts".
Push the carrying ring (1) over the
N
drive tube.
Insert the M5 nut in the hex recess
N
in the carrying ring.
Fit the M5x14 screw.
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
FS 94 R