Table of Contents
Advertisement
Pos.
4
Setpoint adjustment
5
Gas detector
6
Additional settings buttons
Setpoint control method
Pos.
A
Local
B
Dynamic
C
Remote
Slaves
The Slaves view is discussed in section Master–Slave operation: setting up parallel
units.
Dynamic setpoint
The Dynamic setpoint view allows you to specify outlet (flow) temperature values
that will apply at specific outdoor temperatures. The actual setpoint will be calculated
based on the current outdoor temperature (or process temperature) and these outlet
temperature values (Pos. 6 in the figure).
EXEP01 2150EN
Item
Adjust the setpoint and limit value for each control method
by tapping the value.
Toggle the unit's gas detector (optional) on or off. You will
be prompted to sign in to the Expert level.
Each button will open its own settings view.
● The Slaves view is discussed in section Master—Slave
● The Dynamic setpoint and the Timed setpoint view
Item
A locally-specified setpoint will be used. The setpoint can be specified
either in the Home view or by tapping on the setpoint values in the
Control settings view.
The setpoint will calculated based on current outdoor temperature
and a temperature curve. A temperature curve can be set up in the
Dynamic setpoint view.
A remote setpoint (through a bus connection) will be used.
Description
operation: setting up parallel units.
are discussed below.
Description
47 (64)
Advertisement
Table of Contents
