Trane Exergy P30 Installation And Operation Manual page 47

Compressors
Each compressor's current power is expressed as a percentage (shown as a number
inside the compressor's icon). The compressor color codes are shown in the table
below.
Color
Grey
White
Green
Blinking red
If a compressor has a restart delay (greater than 0), the delay is displayed under the
compressor's icon.
To view a compressor's motor status, tap on the compressor's icon. The Motor status
popup will be discussed in section Viewing motor status.
Key process values
Process screen center ver. 3
A number of key process values are shown in the center of the process view.
A
Pres
Evap Evaporating pressure
Temp
SH
ExV Expansion valve opening, %
Accessing setting views
To access different settings views, open the Process view and tap on one of the
buttons in the bottom button row (see the figure below). These views are also displayed
when the Startup Assistant is active (during the first start-up, for example). The views
will be discussed in following chapters.
EXEP01 2150EN
Status
Not ready to start
Ready to start
Running
Alarm
Cold side values
Suction pressure
Suction temperature
Suction superheat
B Warm side values
Pres Discharge pressure
Cond Condensating temperature
Temp Discharge temperature
SH Discharge superheat
45 (64)