Part Settings - Roland JD-08 Owner's Manual

Configuring the Settings of This Unit

Part Settings

These parameters configure the overall settings for the parts.
Step
Item Value
buttons
A, B
SEL
[1]
P. U oL 0–127
[2]
[3]
P. P An L 64–r 63
[4]
UoL 0–127
OFF, On
UnSn
[5]
This sets the playing style for applying portamento.
PrtA
norN
[6]
LEgA
Prt. t 0–100
[7]
LEGt OFF, On
[8]
Aft. S -36, -24,
[9]
-12–12
42
Selects the part to configure.
You can also select a part by holding down the [NOTE] button and pressing the [TONE A] or
[TONE B] button.
Adjusts the part volume.
You can adjust this parameter for each pattern.
Sets the pan position for each part.
Adjusts the tone volume.
When this is on, a certain number of sounds (set in each tone) are layered for a unison
effect.
Portamento is always applied.
Portamento is only applied when you play in legato style (playing one key and then playing
the next while holding down the first one).
When portamento is used, this sets the time taken for the pitch to change.
Higher settings make the pitch take longer when gliding to the next note.
When this is turned on and you play a note while holding down the first note (legato style),
the second note you play sounds without its attack portion. This lets you smoothly connect
the pitches without a gap in the notes.
This effect is applied when [SOLO] button is on.
Sets the aftertouch sensitivity.
Explanation