Differential Case And Ring Gear From The Carrier; Drive Pinion From The Carrier - Meritor MS-113 Maintenance Manual

Section 2
Removal and Disassembly
Differential Case and Ring Gear from the
Carrier
NOTE: Before working on the differential carrier,
inspect the gear set for damage. If the gear set is
not damaged, it can be reused. Measure the
backlash of the gear set and record the dimension.
Figure 2.6 . Refer to Section 4.
1. Remove the cotter pins from the side gear
adjusting rings. Figure 2.7 .
Figure 2.6
Figure 2.7
1
1 COTTER PIN
2. Remove the differential bearing cap capscrews
and the cap. Figure 2.8 .
3. Remove the differential adjusting ring and
bearing cup from bolted-on bearing cap side.
Figure 2.9 .
Page 4
Figure 2.8
1
1 CAPSCREWS
2 DIFFERENTIAL CAP
Figure 2.9
1
1 BEARING CUP
2 ADJUSTING RING
4. Remove the differential assembly from the
carrier and place it onto a workbench.
5. Remove the differential adjusting ring and
bearing cup from integral bearing cap side.

Drive Pinion from the Carrier

1. Fasten a yoke bar onto the yoke to hold
the yoke when you remove the locknut.
Figure 2.10 . Refer to Section 9 to build a
yoke bar.
2. Remove the yoke locknut. Figure 2.11 . Remove
the yoke bar.
Copyright 2002
ArvinMeritor, Inc.
2
1
Maintenance Manual MM-0230
2
Issued 07-02