Table of Contents
Advertisement
Figure 4.25
a. Drive the welch plug and bushing toward the outside of
the socket. Use a sleeve that is slightly smaller than the
socket bore. Figure 4.26.
Figure 4.26
b. Clean grease and dirt from the bore before reassembly.
c. Inspect for damage to the housing.
Remove the Axle Shaft from the Axle
Housing
CAUTION
The cross assembly is not greaseable. Do not disassemble
it. Damage to components can result. If the cross assembly
requires service, replace the assembly.
1.
Remove the axle shaft double-cardan joint assembly from
the carrier housing by pulling the assembly STRAIGHT out
of the carrier housing. Do not disassemble the universal
joints, which will void the Meritor warranty. Figure 4.27.
(16579)
Printed in USA
4
Removal and Disassembly - MX-120 and MX-120-HR Series
BUSHING
WELCH
PLUG
4000042b
4000043a
Copyright Meritor, Inc., 2023
Figure 4.27
2.
Inspect the oil seal and bushing in the axle housing for
wear or damage and replace if necessary. If the bushing
must be replaced, install a new oil seal at the same time.
Figure 4.28.
Figure 4.28
Remove the Axle Shaft Without
Removing the Steering Knuckle
1.
Remove the axle shaft double-cardan joint assembly from
the carrier housing by pulling the assembly STRAIGHT out
of the carrier housing.
2.
Inspect the oil seal and bushing in the axle housing for
wear or damage and replace if necessary. If the bushing
must be replaced, install a new oil seal at the same time.
Figure 4.28.
Remove the Axle Differential Carrier
Refer to
Maintenance Manual 5A, Single Reduction Rear
Differential Carriers
for differential carrier maintenance and service
information.
4000044a
SEAL
BUSHING
4000045a
MM-0170 / Revised 03-23
Page 19
Advertisement
Table of Contents
