Gear Sets; Examples - Meritor MS-113 Maintenance Manual

CAUTION
Apply silicone gasket material in a continuous
1/8-inch (3 mm) bead. If you use more than this
amount, the gasket material can break off and
plug lubrication passages. Damage to
components can result.
4. Apply a 1/8-inch (3 mm) diameter continuous
bead of the silicone gasket material around
one surface. Also apply the gasket material
around the edge of all fastener holes on that
surface. Figure 3.14.
5. Assemble the components immediately to
permit the silicone gasket material to
compress evenly between the parts. Tighten
fasteners to the required torque value for that
size fastener. Refer to Section 6.
6. Wait 20 minutes before filling the assembly
with the correct lubricant. Refer to Section 7.
Figure 3.14
1
1 0.125" (3 MM) DIAMETER SILICONE GASKET BEAD

Gear Sets

Refer to the following examples for information on
identifying gear sets with matched parts. Always
check match numbers to verify that the gear set
you will install has matched parts. Figure 3.15.
Maintenance Manual MM-0230
Issued 07-02
Prepare Parts for Assembly
Figure 3.15
2
ALTERNATE LOCATIONS:
1 PART NUMBER, TOOTH COMBINATION NUMBER,
GEAR SET MATCH NUMBER, PINION CONE
VARIATION NUMBER
2 PART NUMBER, TOOTH COMBINATION NUMBER
3 GEAR SET MATCH NUMBER, PINION CONE
VARIATION NUMBER
4 PART NUMBER, TOOTH COMBINATION NUMBER,
GEAR SET MATCH NUMBER
5 PART NUMBER, TOOTH COMBINATION NUMBER
GEAR SET MATCH NUMBER

Examples

Gear Set
Part
Conventional ring
gear
Conventional
drive pinion
Gear Set Tooth Combination Number
Gear Set Teeth
5-37 = gear set
has a five-tooth
drive pinion and a
37-tooth ring gear
Gear Set Match Number
NOTE: Meritor's drive pinions and ring gears are
only available as matched sets. Each gear in a set
has an alpha-numeric match number.
Match Number
M29
Copyright 2002
ArvinMeritor, Inc.
Section 3
1
5
Number Location
36786 On the front face
or outer diameter
36787 At the end at
threads
Drive Pinion Ring Gear
Location Location
At the end at On the front face
threads or outer diameter
Drive Pinion Ring Gear
Location Location
At the end of the On the front face
gear head or outer diameter
3
4
Page 15