Use Of The Remote Control Unit; Batteries; Inserting Batteries - Tascam CC-222SLmkII Owner's Manual

Cd recorder/cassette deck
Table of Contents

Advertisement

1 – Introduction

Use of the remote control unit

Do not expose the infrared receiver (light receptive area
on the front panel) to direct sunlight or intense light for
extended periods of time. Long exposure to this light
may result in failure of the remote control sensor.
When the remote control will not be used over one
month, please remove the batteries to prevent the possi-
bility of battery acid leakage which could damage the
unit. Should leakage occur, remove and discard the
batteries, and wipe the battery case thoroughly with a
cloth. Avoid getting the battery liquid on the skin. After
cleaning, replace with new batteries.
The remote control functions by using an infrared light
signal. When using the unit to control the CC-222SL
other devices that are turned on could be operated by its
signal.

Batteries

If batteries are used improperly, or if leakage or breakage
occurs, the unit will not function.
Please observe the cautions indicated on the batteries and
their packaging to ensure proper usage.
Confirm + and – polarity and follow the indications
when inserting new batteries into the remote control.
Do not use old and new batteries together.
Even if the battery is the same size, the voltage may
differ. Do not use batteries of different specifications
together.
D o n o t a t t e m p t t o r e c h a r g e b a t t e r ie s t h a t a r e
non-rechargeable.
Do not open or disassemble batteries, throw them into a
fire or put them in water.
10
TASCAM CC-222SL
MK
MK
II
If the range of remote operation becomes smaller, or
commands do not always function properly, the batter-
ies have become weak and should be replaced. Always
replace both batteries with new batteries of the same type.
Point the remote control to the remote sensor on the
main unit. Do not obstruct the path between the remote
control and the remote sensor.
II,

Inserting batteries

ª
1. Open the lid.
2. Confirm +/- polarity, and insert two AA batteries.
3. Close the lid.
NOTE
The batteries are not supplied for Taiwan.

Advertisement

Table of Contents
loading

Table of Contents