Playback Modes; Random Playback; Program Playback - Tascam CC-222SLmkII Owner's Manual

Playback modes

The unit can be set to play back a single track, the whole
disc in the created order, the tracks of the disc in a random
(shuffled) order, or a programmed order. This operation
takes place when stopped.
NOTE
Selecting the playback mode is only possible using the
remote control unit.
1 When stopped, press the
remote control repeatedly to cycle the display
through the following:
Normal playback mode. Playback contin-
•
Cont i nue .
ues in the normal order.

Random playback

In this mode, the unit will playback all the tracks on the
disc in random order.
1 When stopped, press the
display shows
Random
2 Press the PLAY key to start random playback.
While playing back, using the track skip function
will move forwards through the random order.
Turn the MULTI DIAL on the unit clockwise or press
the SKIP ( ) key on the remote control.
¯

Program playback

The steps to set up to 99 program steps (tracks) to be
played back in a specified order are as follows:
1 When stopped, press the
display shows
Progr am
2 The display changes to show
meaning that there are no tracks assigned for pro-
gram playback.
3 Use the number keys on the remote control to enter
a track number. There is no need to press the
TER key.
The track entered is assigned to the program step,
and the display changes, showing the track number,
the total time of the program so far, and the step
number, e.g.
2T r 1 4 : 56 03
4 The next program step can then be entered.
NOTE
Steps 3 and 4 above can also be carried out from the
main unit by turning and pushing the MULTI DIAL key.
5 Repeat steps 3 and 4 above until the program is
complete.
6 Press the PLAY key to start playback at the first
program step.
PLAY MODE key on the
key until the
PLAY MODE
.
PLAY MODE key until the
.
,
0T r 00 : 00 00
EN-
.
4 – Disc operations 1 – Introduction
The currently selected track is played and
•
Single.
then playback stops. The
mode.
In this mode, all the tracks on the disc are
•
Random .
played in random order, and the
(see "Random playback" on page 17 below).
The
PROGRAM
•
Program.
(see "Program playback" on page 17 below).
The selected mode is shown in large characters dis-appears
from the display a few seconds after selecting the mode,
and the display returns to its previous mode.
NOTE
You cannot go backwards to previous tracks in the
Random playback mode.
To stop random playback, press the
disc using the key also stops random playback.
EJECT
The display shows the track, the current time dis-
play, and the program step number.
While in program playback mode, using the
keys or the MULTI DIAL
wards in the order set in the program.
Use the key to stop playback temporarily or the
PAUSE
key to stop playback of the program. If the
STOP
key is used, when playback is restarted, it starts from the
first program step.
When stopped, if the
CLEAR
pressed, it cancels the last track entered in the program.
Clear the program by pressing the
display shows . The program is also cleared
Cont i nue
when the disc is ejected, and if the
when playback is stopped in programmed order mode.
The programmed play order is not memorized when the
power is turned off.
If you enter more than 99 program steps, the message
appears on the display.
F u l l !
If the total time programmed goes over 100 minutes, the
message appears on the display.
-- : --
siNGle indicator lights in this
indicator lights
RANDOM
indicator lights in this mode
key. Ejecting the
STOP
SKIP
moves backwards and for-
STOP
key on the remote control is
PLAY MODE until the
key is pressed
STOP
PGM
17
TASCAM CC-222SL II
MK