Never Use A Stabilizer Or Printable Discs; Beware Of Condensation; Use Of The Remote Control Unit; Batteries - Tascam CD-RW900 Owner's Manual

Never use a stabilizer or printable discs

Using commercially available CD stabilizers or printable
recordable discs with this player will damage the mech-
anism and cause it to malfunction.

Beware of condensation

If the unit (or a compact disc) is moved from a cold
to a warm place, or used after a sudden temperature
change, there is a danger of condensation; vapor in the
air could condense on the internal mechanism, making

Use of the remote control unit

≠ Do not expose the light-receptive spot to the direct
sunlight or intense lights of an illumination for extend-
ed periods. Long exposure to the lights may result a
failure of the unit functions.
≠ When the remote control will not be used over one
month, please remove the batteries to prevent the
possibility of battery acid leakage which could dam-
age the unit. Should leakage occur, remove and
discard the batteries, and wipe the battery case thor-
oughly with a cloth. Avoid getting the battery liquid
on the skin. After cleaning, replace with new batter-
ies.

Batteries

If batteries are used improperly, or if leakage or break-
age occurs, the unit will not function. Please observe
the cautions indicated on the batteries and their pack-
aging to ensure proper usage.
≠ Confirm + and − polarity and follow the indications
when inserting new batteries into the remote control.
≠ Do not use old and new batteries together.
≠ Even if the battery is the same size, the voltage may
differ. Do not use batteries of different specifications
together.
≠ Do not attempt to recharge batteries that are non-
rechargeable.
≠ Do not open or disassemble batteries, throw them
into a fire or put them in water.

Connections

The following should be noted when you connect the
unit to other equipment.
It is possible to connect the unit's DIGITAL COAXIAL
IN, DIGITAL OPTICAL IN and ANALOG UNBAL-
ANCED INs (L, R) to other equipment at the same
time. However, the unit can receive signals from only
one digital input at a time.
Currently selected input jack is shown on the display.
1 − Introduction 1-Introduction
NOTE
Never use a disc that has had a stabilizer mounted to it.
The residual adhesive may cause the disc to stick to the
turntable of the CD-RW900. If it sticks to the turntable,
you will need a technician to get it out.
correct operation impossible. To prevent this, or if this
occurs, leave the player for one or two hours with the
power turned on, then turn the power off and on again.
≠ The remote control functions by using an infrared
light signal. When using the unit to control the CD-
RW900, other devices that are turned on could be
operated by its signal.
≠ If the range of remote operation becomes smaller, or
commands do not always function properly, the bat-
teries have become weak and should be replaced.
Always replace both batteries with new batteries of
the same type.
≠ Point the remote control to the remote sensor on the
main unit. Do not obstruct the path between the re-
mote control and the remote sensor.

Inserting batteries

1. Open the lid.
2. Confirm +/- polarity, and insert two AAA batteries.
3. Close the lid.
Audio signals output from the unit are output from the
analog ANALOG OUT jacks, as well as from the DIGI-
TAL COAXIAL OUT jack and DIGITAL OPTICAL OUT
connector simultaneously (but not from the digital out-
puts in stop mode).
9
TASCAM CD-RW900