Table of Contents
Advertisement
Rack-mounting the unit
If you are mounting the unit in a rack, leave 1U of space
above it and 4 inch (10cm) or more of space at the rear.
Use the rack-mounting kit to mount the unit in a standard
19-inch equipment rack, as shown in this section. Remove
the feet of the unit before mounting.
Some notes, precautions and environmental considerations
The CC-222SL
II may be used in most areas, but to
MK
maintain top performance, and prolong operating life,
observe the following notes, precautions and environmen-
tal conditions:
Avoid exposing it to extremes of temperature and
•
humidity and avoid mechanical shocks and vibration.
Keep the unit away from strong magnetic fields (TV
•
sets, computer monitors, large electric motors, etc.).
The nominal temperature should be between 5°C and
•
35°C (41°F and 95°F).
Rel a t ive hu m id it y s hou ld b e 30 t o 9 0 d eg r e e s
•
non-condensing.
As the unit may become hot during operation, always
•
leave sufficient space above the unit for ventilation. Do
not install this unit in a confined space such as a book
case or similar product, and do not put any material
Beware of condensation
If the unit (or a compact disc) is moved from a cold to a
warm place, or used after a sudden temperature change,
there is a danger of condensation; vapor in the air could
condense on the internal mechanism, making correct oper-
ation impossible. To prevent this, or if this occurs, let the
player sit for one or two hours at the new room temperature
before using.
Never use a stabilizer or printable discs
Using commercially available CD stabilizers or printable
recordable discs with this player will damage the mecha-
nism and cause it to malfunction.
NOTE
Never use a disc that has had a stabilizer mounted to
it. The residual adhesive may cause the disc to stick
to the turntable of the CC-222SL
turntable, you will need a technician to get it out.
II. If it sticks to the
MK
1 – Introduction
goods on the unit.
Avoid installing this unit on top of any heat-generating
•
electrical device such as a power amplifier.
Make sure that the unit is mounted in a level position for
•
correct operation.
The voltage selector on the rear panel is only available
•
on units for the North American market. Please set this
to match your local supply. If you are in any doubt in
this matter, consult an electrician.
NOTE
When transporting the unit, always use the original
packing materials. For this reason, we strongly recom-
mend that you save all the packing materials that came
with the CC-222SL
II, in case you need to transport it
MK
in the future.
7
TASCAM CC-222SL
II
MK
Advertisement
Table of Contents
