Rear Panel; Ac In Connector - Sony HDV HVR-1500 Operating Instructions Manual

Rear Panel

VIDEO
IN Y/S-Y/CPST
REF.VIDEO
IN(SD/HD)
IN
TC IN
4 Timecode input/output
5 REF. VIDEO IN (SD/HD) (loop-through output) connectors
a AC IN connector
Use the specified power cord (not supplied) to connect this
to an AC outlet.
b REMOTE connector (D-sub 9-pin)
Use the optional 9-pin remote cable to connect an editing
controller that supports this unit, or a VCR that supports
editing with two units (DSR-2000A/2000AP, etc.), to
connect those devices to this unit for remote control.
c
HDV/DV (HDV/DV input or output) connector
(6-pin IEEE 1394)
This connector inputs and outputs digital video and audio
signals in HDV/DVCAM/DV format.
Connect a nonlinear editor supported by this unit, or a
VCR (DSR-2000A/2000AP or similar) with a two-deck
editing function, using a 6-pin i.LINK cable (not supplied)
to enable remote operation.
Notes
• If the unit is connected to a device equipped with a 6-pin
HDV/DV jack, when you intend to disconnect or
reconnect the i.LINK cable, turn off the device and pull
out the plug of its power cord from the AC outlet
beforehand. If you connect or disconnect the i.LINK
cable while the device is connected to the AC outlet,
high-voltage current (8 to 40 V) is output from the HDV/

1 AC IN connector

R-Y/S-C B-Y
VIDEO OUT (SUPER)
Y/CPST Pr/R-Y/S-C Pb/B-Y/S-Y CPST
OUT1 OUT2 OUT1 OUT2 HD-SDI
SDI
1/2
MONITOR
OUT
AUDIO
4 MONITOR AUDIO connector
section (see page 24)
AC IN
AUDIO
IN
1/3 2/4
AUDIO
OUT
1/3 2/4
IN AUDIO I/O (AES/EBU) OUT
3/4 1/2 3/4
HDV/DV
REMOTE
DV jack of the device to this unit, which may cause a
malfunction.
• When connecting a device that has a 6-pin HDV/DV
jack to this unit, first connect the plug of the cable to the
6-pin HDV/DV jack of the device.
• When searching at speeds in the range +1/2 to +1/30 or
–1/30 to –1/2 times normal speed, the audio signal
output from this connector and monitored on external
equipment may sound differently from the audio signal
played back on this unit.
d MONITOR AUDIO connector (RCA phono jack)
This connector outputs audio signals for monitoring. The
audio signals to be output from this connector can be
selected with the MONITOR SELECT button (see
page 12).
e REF. (reference) VIDEO IN (SD/HD) (loop-
through output) connectors (BNC type)
Input a reference video signal. The two connectors are
loop-through connectors. You can connect the reference
video signal input to the left connector to other equipment
via the right connector (marked
connection is made to the right connector, the left
connector is terminated with an impedance of 75
automatically.
1 Analog video/audio signal input
section (optional HVBK-1505
board required) (see page 22)
2 Analog video/audio signal output
section (see page 23)
3Digital signal input/output section
(see page 24)
2 REMOTE connector
HDV/DV connector
3
). When no
Names and Functions of Parts
Ω
21