Motion Detection - Samsung SNP-3350 User Manual

Chapter 4. Using Web Viewer
• Depending on the type of video, enter an address as from the examples in the following
chart, and then click Play (P). (When using the default RTSP port number, 554, you may
skip entering the port number.)
The followings are examples of addresses for network streaming.
Address
rtsp://<IP>:<SERVICE PORT>/mpeg4unicast
rtsp://<IP>:<SERVICE PORT>/mpeg4multicast
Notes
<IP> : The current camera IP
<Service Port> : The number of the service port +1 that is selected at the
Config Setup → Network menu.
ex) default port : 80 → <SERVICE PORT> : 81
※ W hen using the default RTSP port number, 554, you may skip entering
the port number.
48
NETWORK PTZ CAMERA User Guide
Streaming Engine Settings
For RTSP/TCP and RTP/UDP
For RTSP/Multicast

4.2.1.3 Motion Detection

Configure the camera's Motion Detection operation.
Notes
: Selected Area, : Other Areas.
Category
Enable Check to enable Motion Detection.
Select a sensitivity level for motion detection according to the video display
Sensitivity
settings. 5 levels are available, and 5 is the most sensitive.
Caution
• New settings are saved only if you click the
Apply The button cancels new settings.
NETWORK PTZ CAMERA
Description
button at the bottom of the screen.
49
User Guide