Connecting Monitor; Preparing & Installing Camera Bracket - Samsung SNP-3350 User Manual

Chapter 3. Installing Camera & Network Setup

3.4. Connecting Monitor

Connect the cable to the camera's rear video output terminal and the monitor's video input
terminal.
37x/33x PTZ Network Camera
SNP-3750/3350
• The wiring varies depending on your monitor type and peripheral devices; please refer to the user manual for each device.
• Please make sure the monitor and camera are turned off when connecting them.
• As shown in the picture below, set the 75Ω/Hi-Z switch of each device to Hi-Z for the intermediate video receiver and to 75Ω
for the end device.
SNP-3750/3350
Video Receiver
Caution
• T his product is a network camera that transfers video over a network; the video output terminal is
used to set the imaging range of the camera at installation.
• U sing the terminal for monitoring purposes may cause problems such as degradation in video
quality.
26
NETWORK PTZ CAMERA User Guide
Monitor
intermediate End Device
3.5. Preparing & Installing Camera Bracket
For installation guidelines for brackets and housings, refer to the installation manual that is
enclosed with the bracket or housing.
LAN
SNR-6400/3200
SCC-3100A
CONTROLLER (SUB)
NETWORK PTZ CAMERA
Internet
PC Web View
Internet
PC Web View
RJ45 Cable
Control
Connection
SCC-3100A
CONTROLLER (MAIN)
27
User Guide