Alarm Sensor - Samsung SNP-3350 User Manual

Chapter 4. Using Web Viewer

4.2.3.3. Alarm Sensor

Configure the options to use the Alarm services by attaching a sensor to the camera.
◊Digital In(Sensor) Setup
Category
Use. Check to use a sensor.
"Normal Open" and "Normal Close" are available choices when selecting the type
Type
for a connected sensor.
※ S1: Sensor 1, S2: Sensor 2, S3: Sensor 3, S4: Sensor 4
◊Digital Out(Relay/Alarm) Setup
Category
Select a digital output (Relay1 or Relay2) when certain events are detected: sensor
(S1~4), motion detection (MD), or video analytics(VA).
Relay
For Dur (Duration), select a duration for which to activate a selected relay upon the
occurrence of an event.
Preset : Performs Auto Run to a preset number in the NUM pane. (Refer to 4.2.2 PTZ Page.)
Swing : Performs Auto Run in a selected Swing mode. (Refer to 4.2.2 PTZ Page.)
Mode Group : Performs Auto Run in a selected Group mode. (Refer to 4.2.2 PTZ Page.)
Sequence
Tour : Performs Auto Run in a selected Tour Search mode. (Refer to 4.2.2 PTZ Page.)
Trace : Performs Auto Run in a selected Trace mode. (Refer to 4.2.2 PTZ Page.)
NUM In the Preset mode, Number is used to set up preset numbers.
Check to transfer information about certain events to your FTP server: sensor (Sensor
FTP
1 ~4), motion detection (MD), or video analytics(VA).
76
NETWORK PTZ CAMERA User Guide
Description
Description
Check to send out information about certain events via e-mail: sensor (Sensor 1~4),
E-mail
motion detection (MD), or video analytics(VA).
Check to save the video file of certain events to an SD memory card: sensor (Sensor
Recording
1~4), motion detection (MD), or video analytics(VA).
◊Aux Setup
Category
Duration Select a duration for which to activate a connected Aux.
Caution
• N ew settings are saved only if you click the
The button cancels new settings.
NETWORK PTZ CAMERA
Description
button at the bottom of the screen.
77
User Guide