Table of Contents
Advertisement
motion detection
Events of motion detection can be set to trigger event signal output.
1. From the Setup menu, select the
<event (
)> tab.
2. Click <event setup>.
3. Select <motion detection> from
<event action setup>.
4. Set whether or not to <enable>.
5. Set <Sensitivity>, <Size> and <area>.
6. Set whether to use <Detection result
overlay>.
When a motion is detected, its size and
position is marked with a rectangle on
the screen.
The opaque area near the bottom cannot be
`
set for the motion detection area.
7. Specify the activation time and
activation condition.
For more information about <Activation
`
time> and <Action>, refer to "Alarm input".
(page 83)
8. When done, click [apply (
)].
English _85
Advertisement
Table of Contents
