Sony VPL-W400Q Operating Instructions Manual page 19

To turn off the power
Note on changing picture
1
Press and hold the POWER key on the control panel or the Remote
Commander for about one second.
The POWER indicator flashes in green and the fan continues to run for
about 1 minute and 30 seconds to reduce the internal heat. The
POWER indicator flashes quickly for the first minute. During this
time, you will not be able to turn the power back on with the POWER
key. After about one minute, you can turn on the power with the
POWER key.
2
Wait until the fan stops running and the STANDBY indicator lights in
red; then press the MAIN POWER switch to turn off the main power
(o OFF).
Notes
• Do not to press the MAIN POWER switch while the fan is still
running; the fan will stop while the lamp is still hot, leading to
breakdown.
• To make the lamp life last longer, do not turn off the power at
least for about 10 minutes after turning on the power.
modese
This projector provides you with the various choices of picture modes.
Please select a picture mode taking into account that one which changes
the aspect ratio of the original picture will provide a different look from
that of the original image.
Please also note that if the projector is used for profit or for public
viewing, modifying the original picture by switching picture modes may
constitute an infringement of the rights of authors or producers which are
legally protected by laws.
19
(EN)