Projecting - Sony VPL-W400Q Operating Instructions Manual

Projecting

Rear remote control
detector
Front remote control
detector
3
5
POWER
2
MUTING
PIC
AUDIO
INPUT
RESET VOLUME
1
Press the MAIN POWER switch on the rear of the projector (O ON).
The STANDBY indicator lights in red and the projector goes into the
standby mode.
2
Press the POWER key on the Remote Commander or the control
panel.
The POWER indicator lights in green.
3
Switch on equipment connected to the projector. Press the INPUT
SELECT key on the control panel or the INPUT key on the Remote
Commander to select the input source.
INPUT-A: Selects signal input from the INPUT-A and AUDIO IN L/
VIDEO:
1
O ON ⁄ o OFF
PATTERN PICTURE MENU
MUTING VOLUME
AUDIO RESET ENTER
4
R connectors.
Selects signal input from the VIDEO IN and AUDIO IN L/
R connectors.
(If you have made connections to both the S VIDEO and
the VIDEO connectors, the signal from S VIDEO
connector is selected.)
MAIN
POWER
POWER indicator
2
POWER
INPUT
POWER
SELECT
u STANDBY
LAMP
LIGHT
TEMP
3 STANDBY indicator
(continued)
15
(EN)