Ricoh FT4227 Manual page 497

12 February 1992
5.4 PAPER FEED CLUTCHES REPLACEMENT
[A]
[C]
[D]
[F]
< Common Procedure>
1. Turn off the main switch and unplug the power cord.
2. Remove the rear cover.
3. Swing out the main control board assembly (1 screw).
(1) By-pass Feed Clutch
1. Remove the by-pass feed clutch [A](1 E-ring, 1 connector, and 1 wire
saddle).
NOTE: When reinstalling the clutch, make sure that the clutch stopper
groove engages with the stopper bracket [B].
(2) Relay Feed Clutch
1. Remove the relay feed clutch [C] (1 E-ring, 1 connector, and 1 wire
saddle).
NOTE: When reinstalling the clutch, make sure that the clutch stopper
groove engages with the stopper bracket [D].
(3) Upper Paper Feed Clutch
1. Remove the stopper bracket [D] (1 screw).
2. Remove the upper paper feed clutch [E] (1 E-ring, 1 connector, and 1
wire saddle).
NOTE: When reinstalling the clutch, make sure that the clutch stopper pin [F]
engages with the groove of the stopper bracket.
[B]
[E]
5-41
PAPER FEED