Table of Contents
Advertisement
COPIER INSTALLATION
[B]
[A]
16. Lower the transfer & separation corona unit by pulling down the release
lever [A].
17. Turn the cleaning unit release lever [B] counterclockwise to the upright
position. (The cleaning unit is released from the drum.)
18. Remove the drum protective sheet [C] from the development unit opening.
CAUTION: To avoid damaging the pick-off pawls, remove the drum
protective sheet by pulling the lower side as shown in the
figure.
19. Turn the cleaning unit release lever clockwise to the set position.
20. Remove the cleaning blade lock plate [D].
21. Reset the transfer & separation corona unit [E].
[C]
3-8
12 February 1992
[E]
[D]
Advertisement
Table of Contents
