Table of Contents
Advertisement
238
4-5. Toyota Safety Sense
WARNING
●
If the area of the windshield in front of the front sensor is covered with
water droplets, use the windshield wipers to remove them.
If the water droplets are not sufficiently removed, the performance of the
front sensor may be reduced.
●
If water droplets cannot be properly removed from the area of the wind-
shield in front of the front sensor by the windshield wipers, replace the
wiper insert or wiper blade.
If the wiper inserts or wiper blades need to be replaced, contact any autho-
rized Toyota retailer or Toyota authorized repairer, or any reliable repairer.
●
Do not attach window tinting to the windshield.
●
Replace the windshield if it is damaged or cracked.
If the windshield needs to be replaced, contact any authorized Toyota
retailer or Toyota authorized repairer, or any reliable repairer.
●
Do not install an antenna in front of the sensor.
●
Do not get the front sensor wet.
●
Do not allow bright lights to shine into the front sensor.
●
Do not dirty or damage the front sensor.
When cleaning the inside of the windshield, do not allow glass cleaner to
contact the lens. Also, do not touch the lens.
If the lens is dirty or damaged, contact any authorized Toyota retailer or
If the lens is dirty or damaged, contact any authorized Toyota retailer or
If the lens is dirty or damaged, contact any authorized Toyota retailer or
Toyota authorized repairer, or any reliable repairer.
Toyota authorized repairer, or any reliable repairer.
Toyota authorized repairer, or any reliable repairer.
●
Do not subject the front sensor to a strong impact.
●
Do not change the installation position or direction of the front sensor or
remove it.
●
Do not disassemble the front sensor.
●
Do not install an electronic device or device that emits strong electric
waves near the front sensor.
●
Do not modify any components of the vehicle around the front sensor
(inside rear view mirror, sun visors, etc.) or ceiling.
●
Do not attach any accessories that may obstruct the front sensor to the
hood, front grille or front bumper. Contact any authorized Toyota retailer or
Toyota authorized repairer, or any reliable repairer for details.
●
If a surfboard or other long object is to be mounted on the roof, make sure
that it will not obstruct the front sensor.
●
Do not modify the headlights or other lights.
●
Do not attach anything to or place anything on the dashboard.
■
Installation area of front sensor on windshield
When the windshield is fogging up easily, the glass around the front sensor
may be hot due to the heater running. If the glass is touched, it may result in
burns.
AYGO_OM_Europe_OM99W80E
www.carobook.com
www.carobook.com
www.carobook.com
Advertisement
Table of Contents
