Sherwood Newcastle R-871 Operating Instructions Manual page 37

Adjusting the current channel level
• After adjusting each channel level with test tone, adjust the channel levels either according to the
program sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into
user's memory ("CALIBRATE"), not into preset memory("REFERENCE 1", "REFERENCE 2").
Press the CHANNEL LEVEL button.
1
Select the desired channel.
2
• Depending on the speaker settings("NONE" or "NO" , etc.) and surround mode, etc., some channels
cannot be selected.
• When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected.
Adjust the level of the selected channel as desired.
3
Repeat the above steps ② and ③ to adjust each channel level.
4
• Then the memory mode ("CALIBRATE" or
"REFERENCE 1") is displayed for several
seconds.
• When the memory mode or channel level
disappears, press this button again.
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
DTS LFE or Dolby Digital LFE
( ): Possible depending on whether the surround back channel is set to "2
CH" or "1 CH".
< >: Possible only when the digital signals from Dolby Digital or DTS
program sources that include LFE signal are input.
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the
range of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended
LFE level for some early DTS software is -10 dB.)
If the recommended levels seem too high, lower
the setting as necessary.
36