Table of Contents
Advertisement
Erasing the programmed command
from one button
Perform the steps ③ and ④ in
1
"Entering a setup code" procedure on
page 20 to select the delecting mode
("DELETE").
• Then "BTTN" is displayed on the LCD screen
for several seconds.
While "SEL" is flickering, press the
3
button for the command you want to
erase.
Example: When the button for the command to be
erased is PLAY button.
• "OK" is displayed and then "SEL" is flickering.
Erasing all the commands
programmed under a device mode
Perform the steps ③ and ④ in
1
"Entering a setup code" procedure on
page 20 to select the deleting mode
("DELETE").
• Then "BTTN" is displayed on the LCD screen
for several seconds.
While "SURE?" is displayed, press the
3
ENTER button
•Then all the commands programmed are erased.
While "BTTN" is displayed, press the
2
CURSOR UP(▲)/DOWN(▼) buttons to
select the one command deleting mode
(BTTN), then press the ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, "BTTN" or "LEARN"(all
command deleting mode) is selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step ①.
While "SEL" is flickering, repeat the
4
above step ③ to erase other
commands.
While "BTTN" is displayed, press the
2
CURSOR UP(▲)/DOWN(▼) buttons to
select the all command deleting mode
("LEARN"), then press the ENTER
button.
• Then "SURE?" is displayed .
• If "SURE?" goes off, start again from the
above step ①.
To erase all the commands
4
programmed under other device mode,
repeat the above steps ① to ③ .
23
Hide quick links:
Advertisement
Table of Contents
