Sherwood Newcastle R-871 Operating Instructions Manual page 27

Operating a punch-through function
• While this remote control is set to control a
master device, aim the remote control at the
REMOTE SENSOR of the punch-through
device and press the desired button of the
programmed punch-through controls.
Example: When pressing "PLAY (▶)" button.
Erasing the programmed puch-through
function
Perform the steps ③ and ④ in
1
"Entering a setup code" procedure on
page 20 to select a master device and
the punch-through mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for
several seconds.
While the device is displayed, press
3
the CURSOR UP(▲)/DOWN(▼)
buttons to select the one punch-
through deleting mode("DELETE"),
then press the ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, depending on the
selected punch-through mode, the punch-
through devices and the deleting mode
("DELETE") are selected.
• Then "OK" is displayed and the current punch-
through mode is displayed .
• Then the punch-through device is displayed on
the LCD screen.
While "VOL" is displayed, press the
2
CURSOR UP(▲)/DOWN(▼) buttons to
select the punch-through mode to be
erased, then press the ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, the mode changes as
follows:
→ VOL DELETE
• Then the device is displayed .
While the punch-through mode is
4
displayed, repeat the above steps ②
and ③ to erase other punch-through
function under the same master device
mode.
To erase punch-through functions
5
under other master device mode,
repeat the above steps ① to ④.
26
PLAY CH ←