Ave Current Configuration; At*A - Multi -Link Bandwidth Mode; At*B - Multi -Link Bacp Mode - Avaya CyberGear Alchemy Series Reference Manual

The AT Command Set
AT&W – S .
N

AVE CURRENT CONFIGURATION

This command is used to save the current configuration parameters to profile 0, 1 or 2. If no
profile is specified then the configuration parameters are stored in profile 0.
i.e. AT&W1 - saves the current set of configuration parameters to profile 1.
AT&W - saves the current set of configuration parameters to profile 0.
AT*A – M -L B M .
ULTI INK ANDWIDTH ODE
This command either forces the CyberGear to try to maintain two calls to the required
destination permanently, AT*A0, or to add a second link only when the amount of data
being transferred requires additional bandwidth, AT*A1.
AT*B – M -L BACP M .
ULTI INK ODE
To enable the unit to request additional bandwidth via the PPP Bandwidth Allocation
Protocol the AT*B1 command should be entered. AT*B0 disables this function.
5-8