Qimarox PD2 User Manual page 13


Make sure that users know and observe all safety rules with regard to the machine
and the environment in which it operates.
3.3.5 Maintenance and repair

See also the specific safety regulations for maintenance and repair in section 6.2

Turn off the power supply to the machine with the main power supply switch
before starting any maintenance or repair tasks. Secure the main power supply
switch in the off position with a padlock.

Switch off air service unit before starting any maintenance or repair tasks. After
the air service unit is switched off, it is necessary to vent all cylinders See section
6.2.

Replace damaged or defective parts before putting the machine back into
operation.

Changes and modifications that may affect the safety of the machine can only be
carried out when these changes and modifications comply with the relevant
regulations, legislation, directives and recognized industry standards.

If changes and modifications are outside the scope of specifications given by
Qimarox in this manual and Qimarox has not granted permission changes and
modifications, then the changes and modifications will entirely be the responsibility
of those persons responsible for carrying out the changes and modifications.

Electrical installation tasks must only be carried out by qualified personnel.

Safety devices should never be bypassed or removed.

Remove any tools or objects left on or in the machine before starting the machine.

After having completed maintenance activities, always put all safety provisions (fencing,
covers and other) that have been removed in place again.

Take the appropriate measures for safety when working at heights.
3.3.6 Fork length
Make sure the forks support the pallets over their full length. Ideally the tip of the fork should
protrude slightly from the front of the stack. When the fork protrudes further that's not a
problem.
WARNING
Danger of stack or pallets falling. Using the machine pallet too long will cause
the stack to fall forward or might cause pallets to fall from the top of the stack.
3.3.7 Fork adjustment
To ensure that the pallets are stacked and de-stacked safely, the distance between the forks
must be adjusted according to the size of the pallet. There must be at least 50mm distance
between forks and pallet blocks.
WARNING
Danger of stack or pallets falling. Incorrectly adjusted forks might cause the
stack to fall over or might cause pallets to fall from the top of the stack.
Contact Qimarox with any deviation of pallet sizes for the required lift finger position to match
that specific pallet size!
UM Pallet dispenser PD2 v2.0 EN
Safety
13