Using Remote Commands - Samsung SF-3100 User Manual

Using Remote
Commands
Code
#0 Exits remote control mode.
#1 Changes the greeting message. After entering the command, speak into the handset. When you finish,
press #. If you run out of recording time, the machine stops and plays back the message.
#2 Plays back all messages. The machine beeps and plays all messages. If there are no messages, the
machine beeps four times and waits for another command to be entered.
#3 Stops the ICM play and waits for remote code when playing ICMs (#2, #5).
#4 Skips a message backward. The machine skips the current message and plays the previous one.
#5 Plays back new messages. The machine beeps and plays all new messages. If there are no new
messages, the machine beeps four times and waits for another command to be entered.
#6 Skips a message forward. The machine skips the current message and plays the next one.
#7 Erases the message currently playing, and plays back the next message.
#8 Turns TAM Mode on/off. The machine plays the greeting message when TAM Mode is turned on.
Each time you press #8 thereafter, TAM mode is turned off, then back on.
#9 Erases all the messages.
Activates Message Paging feature. If you do not set up Message Paging before you leave, you cannot
# 1
turn it on from a remote phone. You will hear error beeps.
# 2 Changes Message Paging destination number and activates the feature. Press # 2. When you hear
the confirm tone (two-short double beeps), enter the new destination number. You cannot include # as
a dial number. Use
#.
Deactivates Message Paging feature.
# 3
Exits the fax machine from answering mode.
#
This code is used at a phone extension connected to the same line as your fax machine
3
Enter the Remote Command corresponding to
the operation within ten seconds.
•
When the specified operation is complete, you hear a
short beep. You can then enter another command for
another operation. If you enter a remote code while the
machine is responding to your command, the unit
stops the current operation and performs new opera-
tion. For the Remote Commands, "Using Remote
Commands" below.
4
Press #0 to finish the remote session.
Important: if you don't enter '#0', your machine
might not hang up for several minutes.
The chart below describes which Remote Code you have to
enter for remote operation:
Operation
to insert a PAUSE between numbers. When you finish entering number, press
The Answering Machine
4-9