Download Print this page

Cleaning - Crown DC-6 Installation & Operation Manual

Direct steam counter tilting kettles

Advertisement

Cleaning

Cleaning
Disconnect the power supply to the appliance before cleaning or servicing.
The equipment and its parts are hot. Use care when operating, cleaning and servicing.
Cleaning Procedures
Your kettle should be cleaned immediately after each use.
1. Ensure that steam supply is OFF.
2. Pre-rinse inside of kettle thoroughly and tilt to remove any food particles.
3. Using a nylon brush, clean kettle with a mild detergent and warm water rinse. Never use steel wool or scouring
powder as it will scratch stainless steel.
4. Tilt kettle and rinse thoroughly draining out detergent solution.
Use of cleaning agents that contain chloride, acids or salts are corrosive and may cause pitting and corrosion
when used over a period of time; this will reduce the life of the appliance.
Should pitting or corrosion occur this is not covered by warranty.
Follow the recommended cleaning instructions. Use a mild detergent, warm water and rinse thoroughly.
8
PAGE
OF 12
WARNING
WARNING
Never spray water into electric controls or components!
CAUTION
CAUTION
Do not use cleaning agents that are corrosive.
INSTALLATION & OPERATION MANUAL 10076 REV 6 (04/22)
Direct Steam Counter Tilting Kettles

Advertisement

loading

This manual is also suitable for:

Dc-10Dc-12Dc-20