How To Use - Panasonic MJ-L700 Operating Instructions Manual

How to use

■
Preparations
① Install parts on the motor housing and attach the lid. (See P. GB12-15)
② Prepare ingredients. (See P. GB16-17)
③ Place containers under the juice spout and pulp spout.
When using the frozen cone, placing the pulp container is not necessary.
●
Insert the mains plug into a household mains socket.
④
■
Extracting
1
Press the "I" (ON) button.
2
Feed ingredients into the small feed inlet
slowly and push them down by using
the food pusher.
Feed ingredients little by little
●
approximately every 5 seconds.
When using more than one kind of
●
ingredient, feed them little by little
alternately.
Do not force to push ingredients into the
●
feeding inlet.
In the case of jamming of ingredients
●
or idle running, press and hold the "R"
(REVERSE) button for several seconds.
(See P. GB11)
3
After extracting is completed, press
the "O" (OFF) button and close the
spout cap.
Continue to run until juice pomace or frozen
●
cream is completely extracted. It may cause
difficulty for opening the lid.
■
After use
Pull out the mains plug.
●
Use the tip of cleaning brush to remove the pulp from juice spout and pulp spout.
●
Remove parts and clean them. (See P. GB21)
●
Do not move the juicer by holding the lid or juicing bowl. (Dropping parts may cause injury.)
■
Note
Depending on ingredients (especially hard ingredients), their pulp may mix into the juice.
●
If pulp is disturbing your drink, strain your drink.
When pulp is not coming out or pulp is accumulating back of the pulp spout and top of the juice
●
attachment, turn the switch off and remove them.
The pieces of ingredient may remain in the gap of the squeezing screw.
●
GB18
It is not necessary for frozen recipe.
Small feed inlet