Panasonic MJ-L700 Operating Instructions Manual page 13

Make sure the parts are in correct position.
●
The juicer may not work properly if they are not assembled correctly.
Rubber brushes
Rubber brushes are located at the side of the rotating brush.
■
To detach
Push the rubber brush to the direction
indicated by the arrow mark and take the
part out from the gap.
Do not pull the rubber brush hard.
Note
Gasket
Gasket is located in the centre of the juicing bowl (inner side).
■
To detach
Pull the gasket up.
Rubber plug
Rubber plug is located on the outer bottom of the juicing bowl.
■
Illustrations are the view from the outer bottom side of juicing bowl.
●
To detach
Pull the rubber plug out in the direction of the
arrow.
Cannot be removed from the juicing bowl.
●
Preparation parts
Rubber brush
Gap
To attach
Insert the upper/lower grooves of the rubber
brush into the gap and then slide it all the
way up/down both ends.
To avoid damaging the brush, make sure
●
the upper and lower grooves are in the
correct position.
Gap
Upper
(Long)
Lower
(Short)
To attach
Pushthegasketintoopeningasfigurebelow.
Push
Sectional view
To attach
Push the rubber plug into the opening in the
direction of the arrow until there is no gap.
Insert the groove
to the projected
part.
Top view
GB13