Steering - Husqvarna R 214T Workshop Manual

9.8 Steering

9.8.1 To examine and adjust the steering cables
The tension of the steering cables can decrease after a
period of time. This causes the adjustment of the
steering to change.
Examine and adjust the steering as follows:
CAUTION: Do not tighten the cables too much.
1. Do a check that the steering cables can be manually
moved 5 mm up or down on the steering collar.
2. Loosen the locknuts (A) if the steering cables are too
loose.
3. Hold the cable with a wrench and tighten the
adjuster nuts (B).
4. Examine the cable tension.
5. Tighten the locknuts when the cable tension is
correct.
1676 - 001 - 26.11.2021
9.8.2 To replace the steering cable
1. Disconnect the adjuster nuts from the steering
2. Remove the tunnel cover. See
3. Disconnect the steering cable front connection (B) at
4. Attach the new cable to the used cable if the used
5. Pull out the used cables from the frame to put the
B
6. Make sure that the steering wheel is in the center
A
9.8.3 To remove the steering cable pulley
1. Remove the frame tunnel cover. Refer to
2. Remove the nuts on the rear end of the steering
A
To replace the steering cable on
cables (A). See
page 43 . Hold the cables with a wrench when the
cables are attached to make sure that the cables do
not twist.
covers on page 18 .
the steering chain (C).
cables are not cut.
new cables in the frame.
position when the rear wheels are in center position.
If not, reset the chain on the steering sprocket on the
steering column or adjust the steering cable.
the covers on page 18
cables.
C
B
To remove the
To remove
Repair instructions - 43