Husqvarna R 214T Workshop Manual page 28

3. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
4. Fill with oil if the oil level is below the lower line, but
do not fill above the top line. Refer to
on page 51 for recommended oil.
9.2.5 To remove and install the air filter
1. Remove the air filter cover. Refer to
install the air filter cover on page 19 .
2. Carefully remove the air filter.
3. Clean and examine the air filter.
28 - Repair instructions
4. Install in the opposite sequence.
9.2.6 To examine and replace a spark plug
1. Open the engine cover.
2. Remove the spark plug cap and clean around the
3. Remove the spark plug with a spark plug wrench.
4. Examine the spark plug. Replace it if the electrodes
5. Measure the electrode gap and make sure that it is
Technical data
To remove and
6. Bend the side electrode to adjust the electrode gap.
7. Put the spark plug back in and turn it by hand until it
8. Tighten the spark plug with the spark plug wrench
9. Tighten a used spark plug ⅛ of a turn more, and a
10. Replace the ignition cable shoe.
spark plug.
are burned or if the insulation has cracks or
damages. If the spark plug is not damaged, clean it
with a steel brush.
Technical data on page 51 .
correct. Refer to
touches the spark plug seat.
until the washer is compressed.
new spark plug ¼ turn more.
CAUTION: Spark plugs that are not
tightened correctly can cause damage to the
engine.
CAUTION: Do not try to start the engine if
the spark plug or ignition cable is removed.
1676 - 001 - 26.11.2021