Husqvarna R 214T Workshop Manual page 23

7. Install the rear belt.
8. Install the hydrostatic transmission fan.
9. Install the hydrostatic transmission cable. Make sure
that the hydrostatic transmission is correctly
To adjust the hydrostatic
adjusted. Refer to
transmission cable on page 38 .
10. Install the brake cable on two-wheel drive products.
11. Install the idler spring.
12. Install the rear wheels.
13. Lower the product
14. Connect the hydraulic hoses to the couplings below
the product.
15. Fill and bleed the hydrostatic transmission system.
To replace the oil in the transmission on
Refer to
page 38 .
16. Install the transmission cover.
9.1.6.4 To replace articulated steering bearing
WARNING: Use protective goggles and gloves
when you remove and attach the center spring.
To remove and install the engine
1. Do steps 1–11 in
on page 24 .
2. Disassemble the pivoting rear axle. Refer to
disassemble the pivoting rear axle on page 21 .
3. If your product has a center spring, remove the
center spring. The tension in the center spring is
very high. Use the special tool for center spring to
release the center spring. Refer to
page 3 .
1676 - 001 - 26.11.2021
4. Remove the inner snap ring (A) from the lower
5. Remove the spindle.
6. Remove the outer snap ring (B) and lift out the lower
7. Lift the top bearing from above. If it is necessary, tap
To
8. Attach the new bearings.
9. Assemble in opposite sequence.
Servicing tools on
10. Do a check of the tension of the steering cable.
11. Do a check that the speed control and cables are
12. Bleed the hydraulic system and fill the transmission
13. Do a function test of the product.
bearing.
B
bearing.
the bearing from below.
To examine and adjust the steering cables
Refer to
on page 43 .
correctly adjusted. Refer to
cable on page 36 .
oil tank with oil. Refer to
transmission on page 38 .
A
Hydrostatic transmission
To replace the oil in the
Repair instructions - 23