Husqvarna R 214T Workshop Manual page 14

4. CUTTING EQUIPMENT
Clean the outer and inner surfaces of the cutting deck and the cutting deck cov-
ers.
Do a check of and adjust the cutting height.
Do a check of and adjust the parallelism of the cutting deck. Refer to
check of the parallelism of the cutting deck on page 11 .
Examine the blades. Sharpen and balance the blades if it is necessary. Refer to
To sharpen and balance the blades on page 42 .
5. LAST INSPECTION AND DOCUMENTATION
Do a check of and adjust the engine speed, rpm. Refer to
cable on page 20 .
Make sure that the product does not move in neutral position.
Do a check of the forward drive and the rearward drive on different speeds.
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Operation conditions on page 12 .
14 - Maintenance schedule for the
service center
To do a
To adjust the throttle
First serv- Maintenance interval
icing in hours
50 100
O O
O O
O O
O
First serv- Maintenance interval
icing in hours
50 100
O O
O O
O O
O O
1676 - 001 - 26.11.2021
200
200