Husqvarna R 214T Workshop Manual page 34

6. Remove the transmission belt. Refer to
the transmission belt on page 45 .
7. Remove the 5 screws that hold the rear transmission
and lower the rear transmission.
9.5.3.2 To install the transmission
1. Assemble the rear transmission in opposite
sequence in relation to disassemble. Refer to
remove the transmission on page 33 .
2. Lubricate the axles with corrosion protection before
attaching the wheels.
Note: The spacer sleeves in the wheels have
different lengths. Left: 36.3 mm + washer. Right:
45.5 mm, no washer.
3. Fill with oil and bleed the hydraulic system. Refer to
To bleed the drive system on page 32 .
34 - Repair instructions
To remove
9.5.4 To replace the shaft seals of the hydrostatic
transmission
9.5.4.1 To replace the input shaft seal of the hydrostatic
transmission
1. Remove the cooling fan circlip and then the cooling
fan.
2. Lift the belt pulley up from the input shaft and
remove the circlip below the belt pulley.
3. Clean all the dirt and corrosion from the input shaft
and the area around the seal.
4. Put a screwdriver between the seal and the shaft,
and remove the seal out of the shaft housing.
5. Wind insulating tape around the input shaft to
prevent damage to the new seal from splines and
grooves. Wind from the bottom and continue to the
end of the shaft.
To
6. Put grease on the shaft and on the inner side of the
new seal to make the seal move easily.
7. Put the seal on the shaft with the smooth side up
and press down carefully.
CAUTION: The area around the seal must be
clean. Dirt in the transmission oil can decrease
the lifetime of the hydrostatic transmission.
1676 - 001 - 26.11.2021