Rgb Analog Source To Port 3 - Barco BARON 908 Installation Manual

Source connections

RGB Analog source to port 3

Which signal to port 3 ?
Connect your RGB source with sync on green, composite or separate sync via an interface to Port 3.
Always use an interface (e.g. Barco Magik Interface R9828120) when a computer and local monitor have to be connected to the
projector as the signal cable coming from the computer is limited to 60 cm due to interferences.
The RGB analog input accepts only sources with a horizontal frequency of 32 kHz and higher.
The Baron is installed with a decoder + Limo Pro to connect sources with horizontal frequency lower than 32 kHz.
Pin configuration D9 connector of the Analog input.
1 Not connected
2 Ground RGBS
3 RED
Input selection port 3
With the RCU, press digit button 3
image 6.6
Port 3
Settings on module level
In the case of this second RGB input there are three different settings:
1. 75 W Termination resistor
2. Blue in green switch
3. Force negative sync switch
R101
R81
image 6.7
Second RGB module
6 - 4
4 GREEN 7 Ground RGBS
5 BLUE 8 Hor/comp. sync
6 Ground RGBS 9 Vert. sync
Computer
to computer
to monitor
R41
R21
Magik Interface
(R9828120)
S2
R1
Port on projector
PORT 3
S1 Force negative sync
(ON = Yes)
S2 Blue in green
S1
(ON = Yes)
Termination resistors:
- R1 Red
- R21 Green
- R41 Blue
- R81 H-Sync
- R101 V-Sync
5976418 BARON 908 04122001