Method 3: Via The Wps Button - TP-Link RE230 User Manual

Chapter 2
2 2 2
Use this way if your router has a WPS button. The button might look like one of these:
1. Press the WPS button on your host router, and then press the WPS button on the
extender for 1 second within 2 minutes.
Note:
For more information about using WPS button on your host router, please refer to the router manufacturer's user
guide.
2. Wait until the Signal LED
connection is successful.
Note:
If the LED does not turn solid on, try again or refer to
Browser.
3. (Optional) If the extender connects to a dual band router, repeat steps 1 and 2 above
to connect to the other band.
4. Relocate your extender for optimal Wi-Fi coverage and performance.
1 ) Plug in the extender about halfway between your router and the Wi-Fi dead zone.
The location you choose must be within the range of your router.
2 ) Wait for about 2 minutes until the Signal LED
relocate the extender closer to the router to achieve better signal quality.
Note:
To minimize signal interference, please choose a location which is far away from Bluetooth devices and other
household electronic devices, such as cordless phones, microwave ovens and baby monitors.
Downloaded from ManualsNet.com

Method 3: Via the WPS Button

.
Router
search engine
changes to solid on, which indicates that the WPS
Method 1: Via the TP-Link Tether App
Halfway
Set Up Internet Connection
or Method 2: Via a Web
turns solid white. If it doesn't,
Signal LED:
Suitable location
Too far from router
No connection
Devices
13