Table of Contents
Advertisement
Chapter 2
1. Press the WPS button on your router, and then press the WPS button on the extender
for 1 second within 2 minutes.
Note:
For more information about using WPS button on your host router, please refer to the router manufacturer's user
guide.
2. Wait until the Signal LED
indicates that the WPS connection is successful.
Note:
If the LED does not turn solid on, try again or refer to
Browser.
3. If the extender connects to a dual band router, repeat steps 1 and 2 above to connect
to the other band. Wait until the Signal LED
Note:
If you want to customize the extended network name, refer to
If you cannot find the network names with _EXT in your Wi-Fi network list, this means
that the extender has been connected to a OneMesh router and automatically copied
its wireless settings. For more information, refer to
4. Relocate your extender for optimal Wi-Fi coverage and performance.
1 ) Plug in the extender about halfway between your router and the Wi-Fi dead zone.
The location you choose must be within the range of your router.
2 ) Wait for about 2 minutes until the Signal LED
relocate the extender closer to the router to achieve better signal quality.
changes from from pulsing blue to solid blue, which
Method 1: Via the TP-Link Tether App
turns solid blue, and the setup is done.
Extended Network Names:
Router's network name with _EXT at the end
or
Same as your OneMesh router
Passwords:
Same as your router
Solid On
Configure Wireless
Set Up Internet Connection
or
Network.
OneMesh with Seamless
turns solid blue. If it doesn't,
Method 2: Via a Web
Roaming.
13
Advertisement
Table of Contents
