Table of Contents
Advertisement
A video of this procedure is available at YouTube:
BPZOAqQMD37KjuxaVHVBkH
Procedure
Step 1.
Slide the front operator panel into the assembly bay.
Figure 69. Front operator panel (2.5-inch drive model) installation
Step 2.
Install the two screws to secure the front operator panel.
Figure 70. Screws installation
After you finish
1. Connect the front operator panel cables to the system board. See
35.
2. Install the top cover. See
3. Complete the parts replacement. See
Remove the front operator panel (3.5-inch drive model)
Use this information to remove the front operator panel (3.5-inch drive model).
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Install the top cover" on page
"Complete the parts replacement" on page
"Front panel cable routing" on page
134.
.
Chapter 4
Hardware replacement procedures
140.
83
Advertisement
Table of Contents
