Table of Contents
Advertisement
Figure 119. System-board screws location
Notes:
• The order and locations of screws installation :
1
the lower left side
2
the upper right side
3
the upper left side
4
the lower right side
• For reference, the torque which is required for the screws to be fully tightened or removed is 5.0
+/- 0.5 lb-in.
After you finish
1. Install the processor. See
2. Install the heat sink. See
3. Install the memory modules. See
4. Connect the front operator panel cables to the system board. See
35.
5. Connect the fan cables to the system board by pressing it down until it clicks. See
on page
37.
6. Connect the backplate or the backplane cables to the system board. See
cable routing" on page
7. Install the PCIe riser assembly. See
8. Install the PCIe adapter to PCIe slot 3. See
9. Install the air baffle. See
10. Install the top cover. See
11. Complete the parts replacement. See
12. Reconnect power cords and all external cables.
"Install the processor" on page
"Install the heat sink" on page
"Install a memory module" on page
41.
"Install the PCIe riser assembly" on page
"Install the PCIe adapter (Slot 3)" on page
"Install the air baffle" on page
"Install the top cover" on page
"Complete the parts replacement" on page
5
near front USB 3.0 / 2.0 header
6
near NMI button
7
near the CMOS battery
8
between the SATA connectors and the
system power connector
115.
87.
91.
"Front panel cable routing" on page
"Backplane and backplate
101.
64.
134.
.
Chapter 4
Hardware replacement procedures
"Fan cable routing"
98.
140.
127
Advertisement
Table of Contents
