Lenovo ThinkSystem SR250 Quick Start

ThinkSystem SR250
Type 7Y51 and 7Y52
Quick Start
Your shipping box contains the following items:
SR250

Material box, including printed documentation

If any item is missing or damaged, contact your place of purchase.
Ensure that you retain your proof of purchase and packing material.
They might be required to receive warranty service.
First glance
Server front view:

Four drives model
VGA connector (optional)
USB 2.0 connector
USB 3.1 Gen 1 connector

Ten 2.5-inch hot-swap drives model
USB 2.0 connector
USB 3.1 Gen 1 connector
Front operator panel
Front operator panel
Four drive bays (0-3)
Rack release latches
VGA connector (optional)
Ten 2.5-inch hot-swap drive
bays (0-9)
Rack release latches
Server rear view:

Fixed power supply model
PCIe slot 1
PCIe slot 2
Power connector
USB 3.1 Gen 2 connectors
Ethernet connector 2
Note 1: For the rear view of the redundant power supply model, there
are two power connectors on your server.
Note 2: Depending on the configuration, the illustrations above might
differ slightly from your server.
Setting up the System
1. Install the required solution components.
2. Install the enclosure into the rack.
See the Rack Installation Guide that was provided with the rail kit.
3. Connect the cables.
4. Connect the management controller to the network.
5. Power on the nodes.
6. Configure the system.
For detailed information about installing hardware options and
configuring the system, see the following website:
http://thinksystem.lenovofiles.com/help/topic/7Y51/introduc
tion.html
PN: SP47A37086
Printed in China
Ethernet connector 1
(shared with XCC network
port)
Dedicated XClarity
Controller (XCC) network
connector
VGA connector
Serial connector