Table of Contents
Advertisement
a.
Remove the top cover. See
b.
Remove the power supply unit. See
c.
Disconnect the flash power module cable from the RAID adapter. See
cable routing" on page
d.
Remove the flash power module. See
Step 2.
Remove the two screws.
Figure 94. Cover screw removal
Step 3.
Carefully slide the power distribution board cover forward and lift it out of the server.
Figure 95. Power distribution board cover removal
Step 4.
Disconnect the cables from the power distribution board. See
routing" on page
ThinkSystem SR250 V2 Maintenance Manual
110
"Remove the top cover" on page
"Remove a hot-swap power supply unit" on page
40.
39.
132.
"Remove the flash power module" on page
"Hot-swap power supply unit cable
105.
"Flash power module
78.
Advertisement
Table of Contents
