Table of Contents
Advertisement
A video of this procedure is available at YouTube:
BPZOAqQMD37KjuxaVHVBkH
Procedure
Step 1.
Position the 2.5-inch drive into the 2.5-inch to 3.5-inch drive adapter.
Step 2.
Align the two screw holes in the drive with the corresponding holes in the drive adapter; then, install
the two screws to secure the drive to the drive adapter.
Figure 47. 2.5-inch drive installation to drive adapter
Step 3.
Position the drive adapter with the drive into the 3.5-inch drive tray. Align the screw holes in the
drive adapter and the drive with the corresponding holes in the tray; then, install the five screws to
secure the drive adapter and the drive into the tray.
Figure 48. Installing the screws that secure the 2.5-inch drive and the drive adapter
Step 4.
Slide the tray with the drive into the drive bay from the front until it snaps into position and then
completely close the handle. See
After you finish
1. Install other drives or drive fillers if necessary.
2. Complete the parts replacement. See
3. Check the drive activity LED on the front operator panel to verify if the drives are operating correctly. See
"Front operator panel" on page 16
ThinkSystem SR250 V2 Maintenance Manual
58
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Install a simple-swap drive" on page
"Complete the parts replacement" on page
70.
140.
Advertisement
Table of Contents
