G e n e r a l T r o u b l e s h o o t i n g I n f o r m a t i o n
Use the following information if your print server is not operating
properly.
1.
Verify that the printer is turned on.
If the printer is used on a Monarch Mobile Work Station (MWS),
the MWS unit's power AND the printer must be turned on. The
print server does not function when the printer is turned off.
Verify the print server is functioning.
2.
When the printer is turned on, the print server runs through a set
of power-up diagnostics for a few seconds. All three LEDs blink
momentarily. Then, the LEDs indicate the following activity:
LED Indicators
Orange
Yellow
Green
Yellow & Green
3.
Print a configuration label (see Chapter 1).
Press the test button on the print server for about a second and a
label prints.
6-4 MonarchNet2 Operating Instructions
Status
solid
printer is on
blinking
error
off
printer is off
solid
Ethernet link (wired 10baseT)
blinking
network activity
off
no Ethernet connection
solid
Ethernet link (wired 100baseTX)
blinking
network activity
off
no Ethernet connection
solid
wireless link
blinking
network activity
off
no wireless connection