Table of Contents
Advertisement
Enter the System Location.
4.
5.
Verify the Read Community Name and change if necessary.
6.
Verify the Read/Write Community Name and change if
necessary.
7.
Verify the Trap Community Name and change if necessary.
8.
Enter the Trap IP address, if it does not automatically appear.
9.
Enter the Trap IP port, if it does not automatically appear.
10. Enable SNMP Alerts if necessary. Set which alerts you need to
receive. See "Setting Alerts" for more information.
11. Click Submit when you are finished.
12. Click the Protocols tab.
13. Click Save Re-init Network (on the Protocols tab) before any
changes take effect. Even though you submitted your changes on
the previous screen, they do not take effect until you click Save
Re-init Network. This process takes a few minutes.
Using a Web Browser 3-13
Advertisement
Table of Contents
Troubleshooting
