Table of Contents
Advertisement
Changing the Printer Setup
Only configure the settings required for your network/printer.
Note:
Only the available options for your printer are displayed.
1.
On the Printer Setup tab, set the Ribbon: None, Ribbon, or High
Energy.
2.
Set the Supply Type: Aperture, Die Cut, Black Mark, or
Continuous. If you are using edge aperture supplies, use the die
cut setting. If you are using center aperture supplies, use the
aperture setting.
3.
Set the Feed Mode: Continuous or On Demand.
4.
Enter a value for the Cut Adjust (Position). The range is –300 to
300. This adjusts where the tag is cut.
5.
Enter a value for the Supply Position. The range is –300 to 300.
This adjusts the printer to print at the vertical 0,0 point. Only
adjust on initial printer setup.
6.
Set the Batch Separators: No, Yes, or Long.
Using a Web Browser 3-5
Advertisement
Table of Contents
Troubleshooting
