Default Network - Paxar 9860 Operating Instructions Manual

D e f a u l t N e t w o r k
The default network option allows you to reset the print server to
default settings or factory default settings.
♦ If you select default setting, any defaults set using the SET
DEFAULT Telnet console command are restored.
♦
If you select factory default, the print server is reset to factory
defaults. See "Factory Defaults" for the list of default values.
When the print server is reset to factory defaults, you must
reconfigure all your specific network settings, including IP
address, SSID, etc.
To change the setting, from the Main Menu: Select Setup, Network.
Then follow these steps.
1. Press or
NETWORK

Default Network

2. Press Enter/Pause.
Default Network
Default Setting
3. After you display the option you need, press Enter/Pause.
The print server is reset to your defaults or factory defaults.
4. Press Escape/Clear until you see the Main Menu.
5. Turn off the printer and turn it back on to initialize the factory
settings.
Note: Depending on your printer's boot method, the IP address may
be automatically assigned when you turn on the printer.
The new IP address may not be the same as the previous
one.
2-14 MonarchNet2 Operating Instructions
until you see